Worx Landroid Installation Guide

Welcome to the Worx Landroid robotic mower installation guide. In this video, we’ll go through the steps, tools and information you’ll need when installing your Landroid.

Find out more on the Landroid here –


23 thoughts on “Worx Landroid Installation Guide”

  1. I just got one today. It works fine but I sent it home once from my phone. That's when it hit a no go area around a tree and decided to follow that home. Only it just kept going around and around the tree. Any suggestions?

  2. I have section of about a foot and a half of grass between my patio and swimming pool. If I put boundary wire around pool and patio, will the landroid mower have any issues cutting in-between this section? Thanks.

  3. I have a build in alcove along my garden wall . The wall is 1M tall . The lawn runs to the edge of the wall .The size of the alcove is approx 1200mm wide BY 1200mm in depth BY 600mm in height . Is it possible house this mower discreetly in a built in garage in this alcove ?
    Or can the base / (housing garage) ONLY be located straight along the boundary wire line as shown in the video ?

  4. How close do the wires have to be to each other for the signal to cancel out if i want to create a no zone area? If the wires were approximately two inches apart would that also cancel out the signal?

  5. Hello, I just bought a new Worx L2000 WR155E. Charging it right now – still no wire laid. Downloaded the app and tried to connect WIFI. Go through the guide in the app until I get to the actual connect push putton – which I of course can't click… It simply wont activate. Any advice on how I can move on with the connection and app?? To me it seems as an App flaw…

  6. Did you have any problems with the landroid runnning over and cutting the boundary wire? Mine cut the boundary wire 4 times within the first hour. But my lawn is not a flat as yours, I guess that’s why. This device does horrible on uneven terrain

  7. Quick question: is there a way that I can force the mower to cut the edges through the app? I don’t mean via the schedule but more like a button I can press?

  8. Hello, I just bought a used Worx WR143E. Unfortunately the triangular template for positioning the wire in the corners was not with the robot. Would you be so kind as to tell me the dimensions of this triangle so that I can redo a template? Thanks in advance, Patrice.

Leave a Comment

Your email address will not be published. Required fields are marked *

Translate »